Mazda 4.3 FInal Drive Ring and Pinion Gear Set for FD3s & RX-8

The Mazda 4.30 ratio ring and pinion set is suitable use on the following rotary applications: 1993-1995 Twin Turbo RX-7 and RX-8.
This ring and pinion set will decrease your vehicles acceleration rate but increase its top speed.

A great modification if your not too bothered about trading a little acceleration for lower cruising RPM leading to a little better fuel economy.

Alternate axle ratios are available for special applications. These ratios interchange exactly with the stock parts and should be adjusted to stock specifications (except as noted on the information sheet supplied with the gear set). If you replace your existing gear set with a lower ratio (higher number) gear set you will increase the vehicle’s acceleration and move through the transmission gears quicker, but you will simultaneously reduce the top speed of the vehicle for a given rpm limit. However, if you reduce your existing gear set with a higher ratio (lower number) gear set you will decrease the vehicle’s acceleration and move slower through the gears, but the top speed of the vehicle will increase for the same given rpm limit as in the previous example.

Special Order only, once you have placed your order for this part it cannot be cancelled. This part is non returnable.